Just realized the mist coolant on my Mini Mill isn't the mess I thought it was
Ran a 3 hour pocketing job on 6061 last Friday with the mist setup I swore I'd never touch and the finish came out cleaner than my flood runs, so now I'm second guessing why I waited so long to try it, has anyone else switched over and regretted it?
Careful with the finish though, mist can look great right off the cutter but you might be laying down a fine film you don't notice until the parts sit a few days. In my experience that oil residue pulls dust and chips into the surface and it can stain bare aluminum if you leave it. Also worth checking your air pressure, too much and the mist turns into a fog you breathe all shift, too little and you get spitting and uneven cooling. The other thing people miss is that mist really shines on deep pockets where flood can't reach the cutter, so your good result might be more about getting coolant where it needed to go than mist being better than flood overall. Your mileage may vary based on what coolant you're running and how your shop vents.