DAE finally stop fighting the chipper feed chute and just lower the bed angle?
Spent four hours last Tuesday fighting a pile of green ash limbs at a job in Aurora that kept bridging up in the feed chute of the old Bandit. I was doing the usual thing, shoving them in butt first and kicking at the mess when it stalled out for the fifth time. My ground guy Marco, who has been doing this stuff for like 20 years, walked over and said real flat, "drop the bed an inch and a half and stop feeding the forks." I felt stupid because I had been feeding every piece fork end first out of habit and never once thought about the angle of the bed. Dropped the pins to the lower setting, started feeding butt first with the fork end aimed at the drum, and the whole thing ate through that pile in maybe 20 minutes with no clog. I always thought the lower bed angle was only for big trunk wood but it turns out it helps with all that stringy wet ash too. Now I want to know if that trick works the same on a Morbark or if they have their own thing going on.