Just realized an old lead at the Van Nuys hangar was right about torque stripes
About 6 months ago a lead named Dave watched me sign off a panel and said my torque stripe was too thick to show a slipped fastener. I argued it was fine, but a week later a fuel pump bolt backed off about half a turn and I never saw it move. Now I run a thin stripe and mark it with a Sharpie so any shift shows up. Do you all stripe bolts on the panel itself or only on the hardware, because I keep going back and forth on which one gives a faster walkaround.
Had the same thing happen with a hydraulic line fitting, stripe looked perfect but the damn thing had shifted just enough to leak. Now I do the thin stripe plus a little index mark on the panel itself, way easier to spot during a walk. Dave was right and it bugs me.